Rejected reason: This CVE ID has been rejected or withdrawn by its CVE Numbering Authority.

In the Linux kernel, the following vulnerability has been resolved: drm/v3d: Ensure job pointer is set to NULL after job completion After a job completes, the corresponding pointer in the device must be set to NULL. Failing to do so triggers a warning when unloading the driver, as it appears the job is still active. To prevent this, assign the job pointer to NULL after completing the job, indicating the job has finished.

In the Linux kernel, the following vulnerability has been resolved: mm: clear uffd-wp PTE/PMD state on mremap() When mremap()ing a memory region previously registered with userfaultfd as write-protected but without UFFD_FEATURE_EVENT_REMAP, an inconsistency in flag clearing leads to a mismatch between the vma flags (which have uffd-wp cleared) and the pte/pmd flags (which do not have uffd-wp cleared). This mismatch causes a subsequent mprotect(PROT_WRITE) to trigger a warning in page_table_check_pte_flags() due to setting the pte to writable while uffd-wp is still set. Fix this by always explicitly clearing the uffd-wp pte/pmd flags on any such mremap() so that the values are consistent with the existing clearing of VM_UFFD_WP. Be careful to clear the logical flag regardless of its physical form; a PTE bit, a swap PTE bit, or a PTE marker. Cover PTE, huge PMD and hugetlb paths.

In the Linux kernel, the following vulnerability has been resolved: platform/x86: dell-uart-backlight: fix serdev race The dell_uart_bl_serdev_probe() function calls devm_serdev_device_open() before setting the client ops via serdev_device_set_client_ops(). This ordering can trigger a NULL pointer dereference in the serdev controller's receive_buf handler, as it assumes serdev->ops is valid when SERPORT_ACTIVE is set. This is similar to the issue fixed in commit 5e700b384ec1 ("platform/chrome: cros_ec_uart: properly fix race condition") where devm_serdev_device_open() was called before fully initializing the device. Fix the race by ensuring client ops are set before enabling the port via devm_serdev_device_open(). Note, serdev_device_set_baudrate() and serdev_device_set_flow_control() calls should be after the devm_serdev_device_open() call.

In the Linux kernel, the following vulnerability has been resolved: fs/proc: fix softlockup in __read_vmcore (part 2) Since commit 5cbcb62dddf5 ("fs/proc: fix softlockup in __read_vmcore") the number of softlockups in __read_vmcore at kdump time have gone down, but they still happen sometimes. In a memory constrained environment like the kdump image, a softlockup is not just a harmless message, but it can interfere with things like RCU freeing memory, causing the crashdump to get stuck. The second loop in __read_vmcore has a lot more opportunities for natural sleep points, like scheduling out while waiting for a data write to happen, but apparently that is not always enough. Add a cond_resched() to the second loop in __read_vmcore to (hopefully) get rid of the softlockups.

In the Linux kernel, the following vulnerability has been resolved: Revert "libfs: fix infinite directory reads for offset dir" The current directory offset allocator (based on mtree_alloc_cyclic) stores the next offset value to return in octx->next_offset. This mechanism typically returns values that increase monotonically over time. Eventually, though, the newly allocated offset value wraps back to a low number (say, 2) which is smaller than other already- allocated offset values. Yu Kuai <yukuai3@huawei.com> reports that, after commit 64a7ce76fb90 ("libfs: fix infinite directory reads for offset dir"), if a directory's offset allocator wraps, existing entries are no longer visible via readdir/getdents because offset_readdir() stops listing entries once an entry's offset is larger than octx->next_offset. These entries vanish persistently -- they can be looked up, but will never again appear in readdir(3) output. The reason for this is that the commit treats directory offsets as …

In the Linux kernel, the following vulnerability has been resolved: hrtimers: Handle CPU state correctly on hotplug Consider a scenario where a CPU transitions from CPUHP_ONLINE to halfway through a CPU hotunplug down to CPUHP_HRTIMERS_PREPARE, and then back to CPUHP_ONLINE: Since hrtimers_prepare_cpu() does not run, cpu_base.hres_active remains set to 1 throughout. However, during a CPU unplug operation, the tick and the clockevents are shut down at CPUHP_AP_TICK_DYING. On return to the online state, for instance CFS incorrectly assumes that the hrtick is already active, and the chance of the clockevent device to transition to oneshot mode is also lost forever for the CPU, unless it goes back to a lower state than CPUHP_HRTIMERS_PREPARE once. This round-trip reveals another issue; cpu_base.online is not set to 1 after the transition, which appears as a WARN_ON_ONCE in enqueue_hrtimer(). Aside of that, the bulk of the per CPU state is not reset either, which means there are dangl…

In the Linux kernel, the following vulnerability has been resolved: mm: zswap: properly synchronize freeing resources during CPU hotunplug In zswap_compress() and zswap_decompress(), the per-CPU acomp_ctx of the current CPU at the beginning of the operation is retrieved and used throughout. However, since neither preemption nor migration are disabled, it is possible that the operation continues on a different CPU. If the original CPU is hotunplugged while the acomp_ctx is still in use, we run into a UAF bug as some of the resources attached to the acomp_ctx are freed during hotunplug in zswap_cpu_comp_dead() (i.e. acomp_ctx.buffer, acomp_ctx.req, or acomp_ctx.acomp). The problem was introduced in commit 1ec3b5fe6eec ("mm/zswap: move to use crypto_acomp API for hardware acceleration") when the switch to the crypto_acomp API was made. Prior to that, the per-CPU crypto_comp was retrieved using get_cpu_ptr() which disables preemption and makes sure the CPU cannot go away from under…

In the Linux kernel, the following vulnerability has been resolved: net: sched: fix ets qdisc OOB Indexing Haowei Yan <g1042620637@gmail.com> found that ets_class_from_arg() can index an Out-Of-Bound class in ets_class_from_arg() when passed clid of 0. The overflow may cause local privilege escalation. [ 18.852298] ------------[ cut here ]------------ [ 18.853271] UBSAN: array-index-out-of-bounds in net/sched/sch_ets.c:93:20 [ 18.853743] index 18446744073709551615 is out of range for type 'ets_class [16]' [ 18.854254] CPU: 0 UID: 0 PID: 1275 Comm: poc Not tainted 6.12.6-dirty #17 [ 18.854821] Hardware name: QEMU Standard PC (i440FX + PIIX, 1996), BIOS 1.15.0-1 04/01/2014 [ 18.856532] Call Trace: [ 18.857441] <TASK> [ 18.858227] dump_stack_lvl+0xc2/0xf0 [ 18.859607] dump_stack+0x10/0x20 [ 18.860908] __ubsan_handle_out_of_bounds+0xa7/0xf0 [ 18.864022] ets_class_change+0x3d6/0x3f0 [ 18.864322] tc_ctl_tclass+0x251/0x910 [ 18.864587] ? lock_…

In the Linux kernel, the following vulnerability has been resolved: cachestat: fix page cache statistics permission checking When the 'cachestat()' system call was added in commit cf264e1329fb ("cachestat: implement cachestat syscall"), it was meant to be a much more convenient (and performant) version of mincore() that didn't need mapping things into the user virtual address space in order to work. But it ended up missing the "check for writability or ownership" fix for mincore(), done in commit 134fca9063ad ("mm/mincore.c: make mincore() more conservative"). This just adds equivalent logic to 'cachestat()', modified for the file context (rather than vma).